Wattyl Spraymate Rapid Dry Industrial Enamel Paint Y14 Golden Yellow 400g Aero

Wattyl Spraymate Rapid Dry Industrial Enamel Paint Y14 Golden Yellow 400g Aero

Regular price $24.99
Unit price  per 

DESCRIPTION

• a single pack fast drying general purpose enamel

PRINCIPAL CHARACTERISTICS

• suitable for interior (and short term exterior) use

• for the coating of display racks, waste disposal containers, fire boxes and drums

• not recommended for prolonged exterior exposure, or aggressive chemical environments Note: We advise that you test this product to determine if it is suitable for your particular use.

COLOUR AND GLOSS

• white, signal red, golden yellow, new cat yellow, aluminium, black, gloss

• matt black

BASIC DATA AT 25°C and 50% RELATIVE HUMIDITY

• vehicle type .............................. synthetic alkyd resin

• typical film thickness (per coat) ...... 25 microns (dry)

• touch dry after........................... 5 minutes

• dry to handle ............................. 20 minutes

• hard dry ................................... 16 hours

• recoat time............................... minimum 1 hour

• shelf life (cool, dry place) ............. at least 12 months

RECOMMENDED SUBSTRATE CONDITIONS AND TEMPERATURE

• best coating performance will be obtained with the highest degree of surface preparation

• degrease thoroughly to remove all oil, grease and other surface contaminants • mild steel; remove all rust and any loose material by wire brush or mechanical sander, prime with Spraymate Structural Primer

• non-ferrous metals, galvanised iron, ZINCALUME®, COLORBOND®; abrade using a Scotch-Brite ® pad or wet and dry sandpaper. Do not use steel wool. Degrease, prime with Wattyl Super Etch Primer,

• substrate temperature should be at least 3°C above dew point

• relative humidity should not exceed 85%

INSTRUCTIONS FOR USE

• agitate by shaking the can for at least 2 minutes after the pellet starts to rattle

• apply 2-3 double coats and allow 5 minutes flash off between coats

• adequate ventilation must be continuously maintained during application and curing

• clean up with Mineral Turps

• for recommendations outside those contained in this data sheet, refer to Wattyl

Application Note: when spraying aerosols apply multiple light coats to avoid runs, begin and end coats beyond the edge of the item being sprayed. Aerosols have an optimum operating temperature of between 15-30°C, use outside this temperature range may inhibit spray efficiency. Try to avoid spraying in cold and high humidity conditions. Ensure the aerosol is shaken thoroughly before use. Spray at a distance of 30cm from the object to be sprayed and use slow even strokes. After spraying invert the aerosol and spray until clear gas escapes to avoid blockages.