WATTYL Killrust Satin Enamel Colorbond Riversand 300g Spray Paint

WATTYL Killrust Satin Enamel Colorbond Riversand 300g Spray Paint

Wattyl Killrust Satin Enamel Colorbond Riversand 300g is a fast-drying, anti-corrosive aerosol topcoat designed for colour-coordinated repairs and touch-ups on pre-coated metal surfaces. Factory tinted to coordinate with Colorbond Riversand, it delivers a smooth satin enamel finish for metal maintenance and restoration.

Ideal for suitably prepared pre-coated steel fencing, garage doors, gutters, downpipes and other metalwork, Killrust Satin Enamel helps refresh existing coatings while providing anti-corrosive protection. Its satin sheen makes it suitable for maintaining a consistent appearance across metal fixtures and fittings.

The ready-to-use 300g aerosol allows convenient spray application without separate spray equipment. Suitable for interior and exterior use, it is a practical choice for smaller repairs, colour-coordinated touch-ups and ongoing metal maintenance.

Key Features

• Colorbond Riversand Colour: Factory tinted to coordinate with Colorbond Riversand pre-coated steel finishes.
• Anti-Corrosive Formula: Helps protect suitably prepared metal surfaces against corrosion.
• Smooth Satin Finish: Provides a decorative, low-gloss appearance for metal repairs and maintenance.
• Fast-Drying Topcoat: Surface dries in approximately 30 minutes under specified conditions.
• Convenient Aerosol Application: Ready-to-use spray format for touch-ups without separate spray equipment.

ADDITIONAL INFORMATION

• Brand: Wattyl
• Range: Killrust Satin Enamel
• Product Code: 115309.530
• Barcode: 9300702189197
• Type: Anti-Corrosive Satin Enamel Aerosol Topcoat
• Size: 300g Aerosol
• Colour: Colorbond Riversand
• Finish: Satin
• Gloss Level: 30–35 at 60 Degrees
• Suitable For: Suitably Prepared Pre-Coated Metal Surfaces
• Application: Colorbond Colour Matching, Metal Touch-Ups and Maintenance
• Application Method: Aerosol Spray
• Interior/Exterior: Interior and Exterior
• Recommended Coats: 2 or More Coats
• Coverage: Up to 2m² per 300g Aerosol, Depending on Surface Texture, Porosity and Film Build
• Surface Dry: Approximately 30 Minutes
• Recoat Time: Approximately 24 Hours
• Full Cure: Approximately 7 Days
• Drying Conditions: 25°C and 50% Relative Humidity
• Surface Preparation: Ensure surfaces are clean, dry and free from loose paint, rust, grease and contaminants. Prepare and prime substrates where required before topcoating.