WATTYL Killrust Epoxy Gloss Enamel Delicious Red 4L Anti-Rust Metal Paint

WATTYL Killrust Epoxy Gloss Enamel Delicious Red 4L Anti-Rust Metal Paint

Wattyl Killrust Epoxy Gloss Enamel is an ultra-premium, anti-corrosive metal paint formulated to provide durable rust protection and an attractive high-gloss finish. Its advanced epoxy formula delivers excellent covering power, washability and scuff resistance for metal surfaces.

Suitable for interior and exterior use, Killrust Epoxy Gloss Enamel can be applied directly to properly prepared new and lightly rusted steel or wrought iron without a separate primer. Non-ferrous metals, including galvanised iron, require suitable priming before topcoating.

Featuring a vibrant Delicious Red colour, this 4L enamel is ideal for metal fences, gates, gutters, railings, downpipes and structural steelwork. Apply by brush, roller or spray gun for a smooth, decorative and protective finish.

Key Features

• Anti-Corrosive Epoxy Formula: Provides durable rust and corrosion protection on suitable metal surfaces.
• Direct-to-Metal Application: Can be applied to properly prepared new and lightly rusted steel or wrought iron without priming.
• High-Gloss Delicious Red Finish: Creates a smooth, reflective finish with excellent covering power.
• Scuff Resistant: Tough, washable coating designed to withstand everyday wear.
• Interior and Exterior Protection: Suitable for metal fences, gates, railings, gutters and structural steelwork.

ADDITIONAL INFORMATION

• Brand: Wattyl
• Range: Killrust Epoxy Gloss Enamel
• MPN: 115207.004
• Barcode: 9300702141768
• Type: Single-Pack Anti-Corrosive Epoxy Gloss Enamel
• Volume: 4L
• Colour: Delicious Red
• Finish: High Gloss
• Suitable Surfaces: Properly Prepared Steel and Wrought Iron; Suitably Primed Non-Ferrous Metals Including Galvanised Iron
• Application: Interior and Exterior Metal Painting
• Coverage: Up to 14m²/L per Coat, Depending on Surface and Application
• Recommended Coats: 1–2 Full Coats; 2 Coats for Greater Durability
• Touch Dry: Approximately 4–6 Hours
• Recoat Time: Approximately 16 Hours
• Application Methods: Brush, Roller or Spray Gun
• Spray Thinning: Up to 15% Mineral Turpentine
• Clean-Up: Mineral Turpentine
• Application Temperature: 10°C to 35°C; Avoid Very High Humidity
• Priming Requirements: No Primer Required on Properly Prepared New or Lightly Rusted Steel and Wrought Iron; Prime Non-Ferrous Metals Before Topcoating