WATTYL Killrust Epoxy Gloss Enamel Deep Brunswick Green 4L Anti-Rust Metal Paint
Couldn't load pickup availability
WATTYL Killrust Epoxy Gloss Enamel Deep Brunswick Green 4L Anti-Rust Metal Paint
Wattyl Killrust Epoxy Gloss Enamel is an ultra-premium, anti-corrosive metal paint designed to provide durable rust protection and a smooth, high-gloss finish. Its advanced epoxy formula delivers excellent covering power, washability and scuff resistance for long-lasting metal protection.
Suitable for interior and exterior applications, Killrust Epoxy Gloss Enamel can be applied directly to properly prepared new and lightly rusted steel or wrought iron without a separate primer. Non-ferrous metals, including galvanised iron, must be primed with a suitable metal primer before topcoating.
Featuring a classic Deep Brunswick Green colour, this 4L enamel is ideal for metal fences, gates, railings, gutters, downpipes and structural steelwork. Apply by brush, roller or spray gun for a durable decorative and protective finish.
Key Features
- Anti-Corrosive Epoxy Formula: Provides durable protection against rust and corrosion on suitable metal surfaces.
- Direct-to-Metal Application: Can be applied to properly prepared new and lightly rusted steel or wrought iron without priming.
- High-Gloss Green Finish: Creates a smooth, reflective Deep Brunswick Green finish with excellent covering power.
- Scuff Resistant: Tough, washable coating designed to withstand everyday wear.
- Interior and Exterior Protection: Suitable for metal fences, gates, railings, gutters and structural steelwork.
ADDITIONAL INFORMATION
- Brand: Wattyl
- Range: Killrust Epoxy Gloss Enamel
- MPN: 115205.004
- Barcode: 9300702141713
- Type: Single-Pack Anti-Corrosive Epoxy Gloss Enamel
- Volume: 4L
- Colour: Deep Brunswick Green
- Finish: High Gloss
- Suitable Surfaces: Properly Prepared Steel and Wrought Iron; Suitably Primed Non-Ferrous Metals Including Galvanised Iron
- Application: Interior and Exterior Metal Painting
- Coverage: Up to 14m²/L per Coat, Depending on Surface and Application
- Surface Dry: Approximately 4–6 Hours at 25°C and 50% Relative Humidity
- Recoat Time: Approximately 16 Hours
- Full Cure: Approximately 7 Days
- Minimum Wet Film Thickness: 75 Microns
- Minimum Dry Film Thickness: 38 Microns
- Application Methods: Brush, Roller or Spray Gun
- Clean-Up: Mineral Turpentine
- Priming Requirements: No Primer Required on Properly Prepared New or Lightly Rusted Steel and Wrought Iron; Prime Non-Ferrous Metals Before Topcoating