WATTYL Killrust Epoxy Gloss Enamel Black 4L Anti-Rust Metal Paint

WATTYL Killrust Epoxy Gloss Enamel Black 4L Anti-Rust Metal Paint

Wattyl Killrust Epoxy Gloss Enamel is an ultra-premium anti-corrosive metal paint formulated to provide durable rust protection and an attractive high-gloss finish. Its advanced epoxy formula delivers a smooth, hard-wearing coating with excellent covering power, washability and scuff resistance.

Suitable for interior and exterior use, Killrust Epoxy Gloss Enamel can be applied directly to properly prepared new and lightly rusted steel or wrought iron without a separate primer. Non-ferrous metals, including galvanised iron, must be suitably primed before topcoating.

Ideal for metal fences, gates, gutters, railings, downpipes and structural steelwork, this black 4L enamel provides a decorative and protective finish. Apply by brush, roller or spray gun for metal maintenance, restoration and painting projects.

Key Features

• Anti-Corrosive Epoxy Formula: Provides durable protection against rust and corrosion on suitable metal surfaces.
• Direct-to-Metal Application: Can be applied to properly prepared new and lightly rusted steel or wrought iron without priming.
• High-Gloss Black Finish: Creates a smooth, attractive finish with excellent covering power.
• Scuff Resistant: Tough, washable coating designed to withstand everyday wear.
• Interior and Exterior Protection: Suitable for metal fences, gates, railings, gutters and structural steelwork.

ADDITIONAL INFORMATION

• Brand: Wattyl
• Range: Killrust Epoxy Gloss Enamel
• MPN: 115202.004
• Barcode: 9300702141584
• Type: Single-Pack Anti-Corrosive Epoxy Gloss Enamel
• Volume: 4L
• Colour: Black
• Finish: High Gloss
• Suitable Surfaces: Properly Prepared Steel and Wrought Iron; Suitably Primed Non-Ferrous Metals Including Galvanised Iron
• Application: Interior and Exterior Metal Painting
• Coverage: Up to 14m²/L per Coat, Depending on Surface and Application
• Recommended Coats: 2
• Surface Dry: Approximately 4–6 Hours at 25°C and 50% Relative Humidity
• Recoat Time: Approximately 16 Hours
• Full Cure: Approximately 7 Days
• Minimum Wet Film Thickness: 75 Microns
• Minimum Dry Film Thickness: 38 Microns
• Application Methods: Brush, Roller or Spray Gun
• Clean-Up: Mineral Turpentine
• Priming Requirements: No Primer Required on Properly Prepared New or Lightly Rusted Steel and Wrought Iron; Prime Non-Ferrous Metals Before Topcoating